Fiberglass Care Guide

Wax Annually

WAX ENTIRE UNIT at least once per year. Any carnuba based wax will do a good job. If using a paste wax, allow wax to dry i.e. a haze develops, then remove with a soft cotton rag. This gives the best and longest lasting results.

Use liquid cleaners only

DO NOT USE ABRASIVE CLEANERS like Ajax or Comet; these will scratch the surface. Use liquid cleaners only. There are a variety of cleaners available at your local supermarket.

DO NOT USE SOLVENTS such as lacquer thinner; these are very flammable and will harm the finish. In extreme hard water conditions, mineral deposits may build up over time. These can be fairly easily removed with Arm & Hammer Baking Soda. Make a paste with water and scrub affected areas. Wax after scrubbing.

Acrylic and fiberglass should provide many years of solid service. However, as with anything, a little care is required to maintain the beauty and appearance.

PRODUCTS TO USE

Mild dish detergent (Example: Ivory Liquid Dish Detergent, Dawn Dish detergent, pump spray fantastic, scrubby bubbles, organic cleaners, magic eraser, soft cloth, sponge)

PRODUCTS NOT TO USE

• Bleach/ Bleach Products

• Products containing acids

• Drain Cleaners

• Powdered Cleaners

• Scrubbing pads

• Aerosols

• Ammonia

• Acetone

• Lacquer Thinner

• Floor mats - trapped moisture causes paint to lift

• Anything that can harm the finish as these products have been known to cause issues on brand new tubs and showers

NOTICE! DO NOT KEEP METAL OBJECTS, TOOLS, TOYS, RAZOR SCRAPERS, SCREWDRIVERS, ETC. STORED IN OR ON THE FIBERGLASS FINISH

Click Here for a Printable Guide